Sure, I did try npm I stall after cloning to the modules folder per the installation instructions. I did get an error when doing so, which is probably something to post over on the MM forums. I think it has to do with the module not supporting newer versions of something.
I’m really not experienced with raspberry pi but I can copy paste instructions and codes as requested lol.
Amen. Same boat here. I have too much of it now and I want to start migrating to local control. I’m starting on Shelly devices myself.
What if you made a pin switch in combination with the magnetic switch? Any magnet should work, the magnet from the magnet switch can be replaced with any magnet. Maybe you need a stronger one is all?
I made a solar powered wifi enabled weather station and moisture meter for my garden. The first attempt was my only and it lasted a couple weeks before I noticed the ants liked the heat of the electronics, created a little farm around the box sitting on the ground and then my wife became unhappy about it.
That said I will eventually make another that is elevated from the ground, just haven’t gotten to it yet.
It was only a few days ago but I did however get it working. I had an error on npm start that sam in the MM discord helped me solve and then my other problem with it not showing the module was due to me putting “middle-right” when then is not an option. Fixing those two things now makes it work. Thank you for replying!