StandingCat

deleted by creator

Im guessing the latency here isnt zigbee, but the two cloud components that follow the button.

Yeah it works ok, my daughter uses it all the time. It sets up via Bluetooth for the fingerprint reader and is all local.

I always use my code because I forget about it and ive been using the codes for so long.

I second this lock (and third by my brother’s experience).

I had several zwave locks before giving up and getting these. These have been bulletproof compared to the other battery hungry ones. I was recommended these by my brother who also tried a few and never had luck. The fingerprint sensor is ok, but i didnt care about it just zwave.

I do wish they were a bit more attractive though.

Yeah it is pricey, but if you have a bit of the gear, the addons arent that bad. But the initial cost is hard to swallow.

Do you have any unifi kit? The connect displays are nice and can run the home assistant app.

I recently “started over” but it was more of a rebuild in place. I did room by room. Areas were not a thing when i started so i added everything to a new area. Deleted any automations that targeted that area. Renamed all devices/entities in the area to a standard naming scheme. Then creating a dashboard for that area. Rebuilt the automations one at a time. Letting them bake before starting a new automation. And finishing all automations for that room before starting a new area.

FWIW i use myQ locally with no issues. I use the myq “homekit bridge” to integrate with home assistant locally.

Plugs and condoms too. Don’t forget to wrap your strange usb outlets.

It is two, but the top board is optional. So i think it’s still a sbc with an optional addition on?